Self-aligning ball bearings
Self-aligning ball bearings have two rows of balls, a common sphered raceway in the outer ring and two deep uninterrupted raceway grooves in the inner ring. They are available open or sealed. The bearings are insensitive to angular misalignment of the shaft relative to the housing which can be caused, for example, by shaft deflection
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
- 35 mm x 80 mm x 21 mm skf 1307 ETN9 Self-aligning ball bearings
- 7/8-9 UNC
- 136 kN
- 30 mm x 62 mm x 48 mm skf 11206 TN9 Self-aligning ball bearings
- 1.00 mm
- 27.00 mm
- 65 mm x 120 mm x 31 mm skf 2213 EKTN9 Self-aligning ball bearings
- One Seal
- 2200 rpm
- 70 mm x 150 mm x 51 mm skf 2314 M Self-aligning ball bearings
- 260000 N
- 0.060 in
- 130 mm x 230 mm x 46 mm skf 1226 M Self-aligning ball bearings
- 80.169 mm
- 22.225 mm
- 50 mm x 120 mm x 29 mm skf 1311 EKTN9 + H 311 Self-aligning ball bearings
- 27000 N
- Shield & Seal
- 45 mm x 110 mm x 27 mm skf 1310 EKTN9 + H 310 Self-aligning ball bearings
- 620.0000 mm
- 423000 N