Self-aligning ball bearings
Self-aligning ball bearings have two rows of balls, a common sphered raceway in the outer ring and two deep uninterrupted raceway grooves in the inner ring. They are available open or sealed. The bearings are insensitive to angular misalignment of the shaft relative to the housing which can be caused, for example, by shaft deflection
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
- 95 mm x 170 mm x 32 mm skf 1219 K Self-aligning ball bearings
- 40.000 mm
- 33.00 mm
- 45 mm x 100 mm x 36 mm skf 2309 ETN9 Self-aligning ball bearings
- TSD 3136 U
- 350 N·m
- 55 mm x 100 mm x 25 mm skf 2211 EM Self-aligning ball bearings
- 13000 rpm
- 47.0000 mm
- 30 mm x 62 mm x 16 mm skf 1206 ETN9 Self-aligning ball bearings
- 125000 N
- 116000 N
- 50 mm x 100 mm x 25 mm skf 2211 E-2RS1KTN9 + H 311 E Self-aligning ball bearings
- SAF 036 KA
- 2 x 38151-36
- 85 mm x 170 mm x 32 mm skf 1219 K + H 219 Self-aligning ball bearings
- 180000 N
- 38.00 mm